DIY Tab Curtains

So our bedroom was lacking... something. We have wanted to redo it for a while, new chest of drawers, pictures on the wall etc, but while we lack the funds to do it all at once we thought that new curtains might be a good start. We went looking in Spotlight, for their pre-made ones, however none of the designs or even colours of the big block ones were what we wanted, so we started brownsing in the upholstery/DIY curtains section and voila! A fabric that we both liked.

I bought 4m for $40 and then, the next day, realised I needed more for the tabs along the top, so bought another 50cm. Total $47.50 ($2.50 for the thread).

First step was to cut the 4m piece of fabric in two. Cats don't help too much, esp as they chase the scissors. Don't be fooled by her innocent look in this picture.


I then took the 50cm piece of fabric and cut it into 15cm strips along the width of the fabric. These I then cut into 2. These are for the tabs along the top. Sew up one side with right sides facing and you have your tabs. I made 12 tabs, 6 for each curtain.

Sew up the edges of the big 2m bits of fabric, I left the selvidges on so made sure I had a little bit of the pattern turned over and sewed up both sides.

Then I turned the top over 5cm, pinned 6 at equal spacing points along the top, making sure there was one at the beginning and end. Then did a double line of stitching, one at the top, and one at the bottom of the fold.


Time for hemming. Folded the bottom up twice to form a heavier base to pull the curtains down and sewed along the top. Iron the seams and you're done.


Before:


After: